SparkFun QwiicBus - MidPoint _MAKE_MODULE_TERMINAL 2022 - we've updated this

2022 - we've updated this OLED breakout with an EYESPI connector to make cabling easier with an 18-pin FPC

1x Built-in LRA Vibration Motor

Raspberry Pi 3 and Raspberry Pi Zero

and even smarter software to make Flotilla friendly for everyone

allowing them to easily spin freely when you pull the wire through the access holes

SparkFun QwiicBus - MidPoint _MAKE_MODULE_TERMINAL 2022 - we've updated thisThe SparkFun QwiicBus MidPoint works in tandem with the QwiicBus Endpoint so you can extend the range of your I2C bus and easily tap into it to drop in devices wherever you would like. The QwiicBus uses NXPs PCA9615 IC, which converts the two default I2C signals into four differential signals, two for SCL and two for SDA. The differential signals sent over Ethernet cables from the EndPoint connect to the breakout through the onboard RJ 45 connectors.