100k Potentiometer Through Hole LED It is compatible with Arduino

It is compatible with Arduino IDE and NodeMCU firmware Chip: ESP-8266EX Compatible with Arduino IDE Compatible NodeMCU firmware GPIO pins: 11 1 pin ADC (0 V to 3

Detectors are responsible for the wide detecting field

Gold for these 11K resistors

Any two points the distance more than 3m transmission signal without any increase circuit

Independently Drives 4 N-Channel FET in Half-Bridge or Full Bridge Configurations

100k Potentiometer Through Hole LED It is compatible with ArduinoThe 100K Pot Potentiometer is a three terminal variable resistor that is used to vary or change the resistance. It is used to change different parameters in an electronic circuit, such as voltage, current, and so on. The 100K POT Potentiometer is a passive electronic component that has two end terminals with a resistive element and the sliding contact called the wiper acts as the third terminal. Two other terminals present are used to facilitate